• De officiele Brodit site van de Benelux
  • Totaal overzicht van alle Brodit produkten
  • Overzichtelijk gedeelte voor professioneel gebruik
Taal
Brodit NL Brodit NL
Toggle Nav Toggle Nav
Zoek

Menu

Toggle Nav
Sluiten
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro
Brodit houder Huawei Mate 20 Pro

Brodit houder Huawei Mate 20 Pro

Artikelnummer
711096
Niet op voorraad
€ 24,95
-
+
Voeg toe aan bestellijst Toevoegen om te vergelijken
Gegevens

Keep your phone in a passive holder and you will always have it within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. You have full access to the camera and all buttons and outlets when the device is in the holder. You can connect a charging cable or portable handsfree to the device when it is in the holder.

 

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto ProClip Mounting Platform.

Meer informatie
Meer informatie
Accessoiremerk Brodit
Barcode 7320287110968
Adviesverkoopprijs incl. BTW 24,95
Houder kenmerk Toestelspecifiek
met case/skin/boot/frame ? nee
Kabel / Qi /lader type / connnector passief
Input Voltage n.v.t.
Voltage (output) n.v.t.
Max Amperage n.v.t.
Montage standaard AMPS
Afsluitbaar nee
Kleur zwart
Productinfo Brodit houder
Productinstallatie Monteer de houder op een ProClip in uw voertuig. Gedetailleerde installatie-instructies in de productverpakking aanwezig
Product geschikt voor info Bij het tabblad Compatibility checkt u welk apparaat in deze houder past.
Compatibility
Gerelateerde producten
Gerelateerde producten
Instructies
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.

Annuleer Ga verder met winkelen
Scroll to top