• De officiele Brodit site van de Benelux
  • Totaal overzicht van alle Brodit produkten
  • Overzichtelijk gedeelte voor professioneel gebruik
Taal
Brodit NL Brodit NL
Toggle Nav Toggle Nav
Zoek

Menu

Toggle Nav
Sluiten
Proclip Honda Accord 03-07 Angled mount
Proclip Honda Accord 03-07 Angled mount
Proclip Honda Accord 03-07 Angled mount
Proclip Honda Accord 03-07 Angled mount
Proclip Honda Accord 03-07 Angled mount

Proclip Honda Accord 03-07 Angled mount

Artikelnummer
853200
Niet op voorraad
€ 29,95
-
+
Voeg toe aan bestellijst Toevoegen om te vergelijken
Gegevens

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

Meer informatie
Meer informatie
Accessoiremerk Brodit
Barcode 7320288532004
Adviesverkoopprijs incl. BTW 29,95
Montage opties Proclip stuur links
PCM montage positie Rechts
Kleur zwart
Montage standaard AMPS afmeting, zonder gaten
Productinfo Grotere apparaten of zwaardere apparatuur monteren? Zie daarvoor Proffesionele toepassingen
Productinstallatie Deze ProClip is snel en eenvoudig te monteren steun. Montage zonder beschadiging van dashboard of interieur. Er is geen speciaal gereedschap benodigd.
Product geschikt voor info Bij het tabblad Compatibility checkt u de auto's die geschikt is/zijn voor deze Proclip.
Compatibility
Instructies
1. Attaching part (the smallest part), 1. Press the thin end of the enclosed gap opener into the gap between the control panel frame and the dashboard to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap below the gap opener.
2. ProClip face plate, 2. Press to the right on Part 1, away from the steering wheel, so the angled edge hooks behind/under the control panel frame and the adhesive tape attaches. Pull out the gap opener.
3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Remove the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match and the adhesive tape is on the left side. Screw Part 2 onto Part 1 with the enclosed screw. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1, do not screw the screws into place basing the angle on Part 2.
4. The ProClip is in place.

Annuleer Ga verder met winkelen
Scroll to top